Tools & Equipment
Several recent donations have left us with a lot of stuff in the shop, some of it still not evaluated or categorized. While all the equipment is here for use in shop projects and by shop members, we have a few donations that are "Free to a Good Home". Other equipment should remain for common use.
Free To A Good Home
- A crap ton of CRT monitors.
- A large couch.
- A set of speakers.
- An electric stove
Shelving Specs
- Main Shelves (5 shelves, along the wall as you enter the shop):
- Height 14.25" clearance, except the second shelf up from the bottom has 17.5" of clearance, and there is just over 24" of clearance from the top shelf to the pipes.
- Depth: 24" of shelf proper, plus another 2.75" to the wall.
- Width: 44-46" between uprights, but shelves are open end-to-end.
- Book shelves to the left of the nook: (6 shelves + long top shelf (not measured))
- Height: 14", though each end of the shelf is only 12" (sideways 2x4 support for shelf above)
- Depth:16" of shelf proper, plus another 2"(ish) to the wall
- Width: 27" (barely)
- Utility Shelves to the right of the nook: (5 shelves + long top shelf (not measured))
- Height: 17" (bottom four shelves), 13" (5th shelf (below the long top shelf))
- Depth: 19.5" of shelf proper, plus another 2"(ish) to the wall
- Width:40" of shelf proper, plus another 1.5" to the whiteboard
- Small nook (5 shelves, between previous two shelves):
- Height: 13.75" (top shelf goes up into ceiling, not measured)
- Depth:24.5" of shelf proper, plus another 2"(ish) to the back wall
- Width: 51" support-to-support, plus about 1.5" on each side to the wall
Books
Are cataloged in the Library.
Current Inventory
Ham Radio
- Radio Shack HTX-202 2 Meter Handie Talkie
- Needs to be charged and tested.
- Reminder: Ham Radio requires a license to transmit, but everyone can listen.
Basic Hand Tools
- Flat head screwdrivers
- Phillips screwdrivers
- Box cutters
- Tape measures
- Vise-Grips
- Saws
Table Tools
- Drill Press
Miscellaneous
- Angle Grinder
- Welding machine
- Digital projectors (2)
- 8.25" table saw with fence; could use a push miter.
- 10" single-bevel miter saw
- Metal lathe
- Sony SCARA robot arm: can be freely gutted for parts
- Adept SCARA robot arm + controller: contact Marek to discuss configuration for shop or project use
Advanced Tools
- Laser Cutter
- 3D Printer
- Metal lathe
- CNC Router
Electronics Tools
- Multimeters (many)
- Oscilloscopes (many)
- Logic Analyzer
- bench power supplies
- common components (LEDs, caps, resistors, wire, etc.)
Just acquired
- Laser Cutter
Wish List
- CNC Mill